  
Maxon VOP-9 Vintage Overdrive Pro Pedal - Free Shipping
Not in stock right now
MAXON VOP-9 VINTAGE
OVERDRIVE PRO.
Vintage Overdrive Pro VOP9 adds natural and warm nuance to your guitar
sound like that of a good vintage amp. Specially designed circuit
reacts precisely to every fingering or picking nuance with minimal
compression. VOP9 combines functions of clean booster and overdrive.
With Drive Control level set to minimum, the overdrive circuit works as
a -12dB attenuator, and the clean boost circuit as a 6dB booster to
create clean and flat boost sound. When turning up the drive level
control, signal from overdrive circuit is blended in against clean
signal until full overdrive tone is reached at Drive Control maximum
level setting.
JRC NJM4558D IC op-amp offers low-noise overdrive sound. The overdrive
circuit is the same as OD9, using a diode in op-amp negative feedback
loop. Operating voltage is switchable via an internal DIP switch
accessible through the unit’s battery compartment. Improved
operation at 18 volt setting eliminates unintentional distortion caused
by high-output pickups and active electronics. VOP9 exemplifies its
overdrive performance when connecting to tube amp with high dynamic
input range.
- True Bypass Switching with 4PDT mechanical switch. No tone changes
when switching bypass and effect.
- Two-way power operation, using 9V alkaline battery or optional AC
adaptor. (9V alkaline battery: more than 20 hours at plus/minus 4.5V)
Easy-access, tool-free battery compartment.
- VOP9 uses a stabilized DC to DC voltage converter to bump 9V (plus
and minus 4.5V) up to 18V (plus and minus 9V). Battery voltage drop and
fluctuation of AC power source do not affect the tone and function.
Input Impedance: 500K Ohms
Input Jack: 1/4 inch standard phone jack
Output Impedance: 10K Ohms
Output Jack: 1/4 inch standard phone jack
Outputs: 1
Maximum Gain: 41.5 dB
Residual Noise: -98 dB or less (input shorted IHF-A weighted)
Controls: Drive, Tone, Level
Switch: Normal/Effect (true bypass configuration w/4PDT switch)
Power Supply: 6F22 9V Manganese dry cell battery x1 or Maxon AC adaptor
Power Consumption: 25 mA (9 V) or 25 mA (10 V)
Dimensions: 74 mm (W) x 124 mm (D) x 54 mm (H)
|